Heat Shrink End Cap, 8 mm, ID x 25 mm, L 2:1, Waterproof, Electric, Self-Adhesive, Lined, Sealed, for Wire, Pack of 50

The cable's shrink-resistant cap is coated with hot melt adhesive on the inside and may shrink when heated. The cable sealing cap remains firmly attached to the surface of the cable after the glue has melted. Provides sealing, sealing, insulation and protection for steering and power cable lugs. Shrink ratio: 2:1; Rated voltage: 35 kV; Operating temperature: -55 °C ~ 125 °C; initial shrinkage temperature: 80 °C; full shrinkage temperature: 120 °C; size: 8 x 25 mm (ID*L) This component has remarkable chemical corrosion resistance, as well as good insulation properties and heat resistance. With a shrink ratio of 2:1, the inner hot-melt adhesive layer provides an airtight seal and facilitates easy and practical placement at cable ends. The melted spiral adhesive on the inner layer of the shrink coating retains wonderful flexibility after contracting. Place a heat shrink tube on the outer protective layer where the cable ends. Heat the heat shrinkable cable gland to shrink the end of the cable. It should have a large control of the heating temperature. Stop heating if the shrinkage is in place and the glue overflows. Product tolerance from 3 to 5 mm.